Materials are sent by the inlet into the sand maker which will then divide materials into two parts by the distributor. One part of the materials moves from the middle of the distributor into the high-speed rotating impeller. The sand making machine in the impeller is accelerated rapidly, and its acceleration speed can be up to several hundred times of the gravitational acceleration speed, then the materials are ejected from three uniform flow channels of impeller at the speed of 60-70 m/s. Another part of the material, entering into the crushing cavity in a scattering way through the distributor, crash with the materials fast ejected from the channel. This is the working principle of vertical shaft impact sand maker. After knowing the working principle of sand making machine, how can we improve the production capacity of the sand making machine?

Then our Shunky engineers will tell you in detail that how to make highly efficient production of sand maker: first, in the set of the feeding device of sand making machine, we must adopt unified process to reduce grade differences to the minimum in feeding. Secondly, the feeding should be even so as to ensure uniform feeding; the size of feeding particle should be the same or not be too different. If the size of the stone for crushing and making sand is mixed with big sizes and small sizes, the efficiency of making sand will be reduced. Through the above two ways, we can improve the production capacity of sand maker. Classification and screening can be equipped at the discharge hole of the sand maker so as to reduce unnecessary loss. Finally, it is important to notice that, in the process of making the sand maker work efficiently, we also need to do a good job of maintenance of sand maker. Only the maintenance work is well done can we make sure the sand maker work for us efficiently for a long time.